Kathrein MFK 16 Manual de usuario

Operating ManualDVB-T MeterMFK 16

Selecting different measuring methodsThe meter is able to measure the RF signal level (analogue and digital channels), “BER” (Bit Error R

Getting startedAligning an antenna / BER modeIf neither a bar nor DVB-T appears on the display, the signal is too low or the transmission is analogue.

12Getting startedSwitching off the meterTo switch off the MFK 16, press and hold down the “OFF” button for about 5 seconds. The display shows “Power o

13The cursor indicates the selected function. Press the left or right arrow button to make changes. The display shows the status of the function.The f

14Technical data• Display of signal levels of terrestrial signals• Display of carrier-to-noise (C/N) ratio• BER measurement pre and post Viterbi•

15

Internet: http://www.kathrein.de KATHREIN-Werke KG • Phone +49 8031 184-0 • Fax +49 8031 184-306Anton-Kathrein-Straße 1 – 3 • P.O. Box 10 04 44 • 8300

PrefaceDear customer,KATHREIN-Werke KG has made every effort to ensure the accuracy and completeness of this manual. However, no liability can be acce

ContentsPreface 2Contents 3General information 4Product package 5Safety instructions – important notes 6Charging the battery 8 Charging usin

The MFK 16 DVB-T signal meter meets the highest quality standards based on its design and highly reliable workmanship. DVB-T signal

Product packageMFK 16 signal meter with integral battery, protective bag and carrying strapThe MFK 16 product package includes:- MFK 16 signal meter,-

6Safety instructions – important notesThis page contains important information on operating and connecting up the unit.Read these instructions careful

• When operated from the mains there is danger to life if the unit is not handled correctly• Do not expose the unit to dripping or splashing water•

Charging the batteryWhen shipped, the battery is not charged. We recommend you leave the battery on charge for 24 hours before using it f

Getting startedConnect the MFK 16 input on the front of the unit by a BNC cable to the antenna. Alternatively, you can use the BNC/IE